Little things
Got these a while ago, conrods from an M20B20 - 130mm center to center. 5mm shorter than the standard M20B25 and will mate well with the M52 crank! Spent too...
Thar be ‘oles in that dash!
Gauges! Hole cut and the gauges are resting in there - looks really good :D Our dad had an adjustable bit for his lathe he made many years ago which...
Dash
Time has come to spend hours and hours debating where to put the gauges! After many, many permutations using prints outs and bluetak here's the results: Dash masked and all...
A few changes to the site!
We've add a new preview function to all images on the site, it's now no longer necessary to download large images to get a closer look at each one. Just...
Wires, bodywork and parts
Wiring We've made excellent progress with the wiring, pretty much everything is in place now ready to go! Bodywork Rear lights are in and the tank filler hole is drilled....
New gallery section
New gallery section - Other peoples pictures These are various pictures taken by other people that I've found on the net. Please contact me if you would like any of...
Mixture Adjust and a bit of fun!
A final round of engine tuning! Decided to set the idle mixture today as the engine was very obviously running rich. Got the gunson gastester out and it verified the...
Vucuum and Idle
One way vacuum valve conversion. A left over part from Richard's E36 Compact engine conversion! Blocked off the hole in the intake boot and one of the two holes on...
Quiet weeked
Not done much this weekend, taken care of a few small things such as the battery holder. Also tried running the car with the original ecu chip - no difference...