Various brackets and panel for ECU wiring in bulkhead
Coil finds a home on the other side of the engine bay. A little bit of re-jigging is needed on engine wiring loom.
Engine wiring loom, not quite fully wrapped yet - it will get a heat shield too.
Wiring inside, just loose for now
This is where the engine loom will connect to the car loom!
Coil in place with all the hoses in their final positions
Another pic of the coil and pipes
Cooling pipes
Alloy wheel restoration before and after shot. The one on the right had a 2mm deep hole cut into it. Filled this up and spend several hours sand everything flat. The whole rim lip had curb marks on similar to those on the un-restored wheel.