Bonnet

If ever there was a job for two people its putting the bonnet on! Took a lot time of measuring, eyeing up and fiddling.

This is not 100% final yet. The whole panel is slightly over size most of the way round by around 1mm to allow for fine tuning once everything else is in place. With the clamps in place this will side nice and flat the whole way along – right now the masking tape is not holding it very well!

Hinge attached at the scuttle – will be putting a pictures of the front up too but the file for that one broke for some reason!

Biggest tip we can give here is getting a permanent marker and draw lines and guides everywhere – the rubber moves around a lot so by drawing your ideal line directly on the scuttle and nose cone you’ve got a line to follow.

Leave a Reply

Your email address will not be published. Required fields are marked *